Measurement Instructions: It is essential to measure the driveshaft length while the vehicle's axle is in its normal riding position. Ensure the axle is properly supported on safety stands and not suspended. This procedure is critical for obtaining accurate measurements.
Measure from end of rubber seal on the transmission to the flat face of the end yoke or flange on the differential.
Measure from end of rubber seal to the end of the transmission output. If spline is recessed in rubber seal, measurement can be noted as Ø.
Measure from end of rubber boot extension on the transmission to the flat face of the end yoke or flange on the differential.
Measure from end of rubber boot extension on the end of transmission output. If spline is recessed in rubber boot extension, enter Ø.
Measurement Instructions: It is essential to measure the driveshaft length while the vehicle's axle is in its normal riding position. Ensure the axle is properly supported on safety stands and not suspended. This procedure is critical for obtaining accurate measurements.
Measure from center of u-joint / flats on the end yoke on the transmission output to the face of the end yoke or the face of the flange on the differential input end.
Measure from the flat of the flange on the transmission output to the center of the u-joint on the end yoke or the face of the flange on the differential input end.
Fill out the form below and we will contact you with the right fit part number.
Have your measurements? Browse ready-to-ship one-piece driveshafts, or send us your numbers and we'll match the right part.
Shop Premade Driveshafts